WaveCombo Software Development Kit

WaveCombo Software Development Kit (SDK) enables users to develop dedicated short range communications(DSRC) applications along with non-DSRC applications based on integrated 802.11p, 802.11abgn, Bluetooth Classic, Bluetooth Low Energy and 802.15.4/ZigBee.

This SDK contains all the necessary software and hardware needed for hardware evaluation and development of applications. The kit contains a Freescale i.MX6 processor, WaveCombo module, GPS receiver, dual band antennae with DSRC support, power supply adapters, embedded software (binarycode), WaveCombo software configuration management system, and device drivers.

Source code is available for licensing separately. Two sets of hardware boards are provided with the SDK to do a complete end to end development and testing.

The SDK can be used for the following activities:

  • Evaluation of performance of the radio
  • Execution of a set of pre-defined applications (such and Emergency Electronic Brake Lights and Road Side Alert) in field as well as laboratory
  • Development of DSRC and non-DSRC applications based on 802.11p. 802.11n, Bluetooth, 802.15.4/ZigBee
  • End-to-end testing of the applications (each of the boards can be configured as an OBU or RSU)
  • 802.11p
  • 802.11abgn
  • 802.15.4
  • Bluetooth 4.0 Dual Mode (BT 2.1 + EDR, LE)
  • SAE J2735
  • IEEE 1609.x
  • 802.11p
  • 802.11abgn (Access Point, Client, Simultaneous AP/Client)
  • 802.11abgn + Bluetooth
  • 80211abgn + 802.15.4/ZigBee
  • Bluetooth
  • 802.15.4/ZigBee
  • 802.11p: 5 MHz and 10 MHz
  • 802.11n: 20 MHz and 40 MHz
  • Wi-Fi: 2412 MHz to 2484 MHz; 4910 MHz to 5825 MHz
  • 802.11p: 5850 MHz to 5925 MHz
  • Bluetooth: 2402 MHz to 2480 MHz
  • 802.15.4/ZigBee: 2405 MHz to 2480 MHz
  • 802.11p (Mbps): 3, 4.5, 6, 9, 12, 18, 24, 27
  • 802.11n: MCS0 to MCS7 (with and without short GI)
  • 802.11a/g (Mbps): 6, 9, 12, 18, 24, 36, 48, 54
  • 802.11b (Mbps): 1, 2, 5,5, 11
  • Bluetooth (Mbps): 1, 2, 3
  • ZigBee: 250 kbps
  • 802.11p: +23dBm (+/- 1 dBm) at 64 QAM with Class C Mask; -94 dBm Receiver Sensitivty
  • 802.11n: +23 dBm (+/1 1 dBm) at 64 QAM; - 97 dBm Receiver Sensitivity for 2.4 GHz and -94 dBm Receiver Sensitivity at 5 GHz
  • Bluetooth: Class-1 Transmit Power up to +20 dBm; -94 dBm Receiver Sensitivity
  • ZigBee: +19 dBm Transmit Power; -102dBm Receiver Sensitivity
  • Temperature: -40C to +85C
  • Transmit Center Frequency Tolerance (802.11p): +/- 5ppm across -40C to +85C and all data rates
  • Channel Rejection (802.11p):
    • Adjacent Channel: 25 dB - 3 Mbps; 15 dB - 27 Mbps
    • Non-Adjacent Channel 45 dB – 3 Mbps; 23 dB – 27 Mbps
  • Control Channel (CCH) and Service Channel (SCH) Coordination
  • <1ms channel switching time between CCH and SCH
  • 50ms channel dwell time in CCH and SCH
  • CCH for broadcast, high priority and single use safety messages and SCH for IP data
  • Alternative Channel Switching
  • Continuous Channel Switching
  • Extended Channel Access
  • Software Queuing
  • Prioritized channel access queues with configurable channel access parameters
  • GNSS (GPS, GLONASS, QZSS) with PPS for timing synchronization; <1m accuracy
  • Bluetooth for interfacing with Smart Phone and CAN bus
  • 10/100/1000 Mbps Ethernet (RJ45) with PoE
  • USB 2.0 OTG
  • USB 2.0 Host
  • HDMI Display Port
  • Serial Console
  • CAN
  • Digital I/Os
  • BroadR Reach automotive Ethernet*
  • IEEE 1609
  • ETSI ITS G5*
  • Linux
  • Automotive Grade Linux, Android, QNX*
  • TX power control per packet
  • Data rate control per packet
  • Signing and verification of messages
  • Encryption and decryption of messages
  • Sigining and verification of WSAs
  • Local certification manager and SCMS support
  • IEEE 1609 certificate update
  • Time limited IEEE 1609 certificate
  • TX/RX packets
  • System events
  • Log offload configuration (IPV4 or IPV6)
  • WAVE service announcement configuration
  • Smart phones with Bluetooth interface (audio and data)
  • BSM, TIM, Map, SPaT, RSA, SSM
  • TX and RX of supported SAE J2735 messages
  • Emergency Electronic Brake Light (EEBL) with Bluetooth message output (audio and data)
  • Road Side Alert (RSA) with Bluetooth message output (audio and data)
  • Linux based tool chain (with integrated drivers and stacks)
  • IEEE 1609 API Library
  • Wi-Fi API Library
  • Bluetooth API Library
  • 802.15.4/ZigBee API Library
  • FlexCAN/J1939 API Library
  • Sample Applications
  • SDK User Guide
  • SDK Quick Start Guide
  • SAE J2735 ASN Library
  • IP Protocols: IPV4/IPV6
  • Interactive Communication: SSH, Telnet

Product Order Information

Product Number: WaveCombo-SDK1

Description: Software development kit for WaveCombo (WCMBA1-NBZ-D0P) module

Price: The cost of the complete kit with the hardware, drivers, 1609 stack as well as sample applications is US $20,000.

Please contact Redpine sales at sales@redpinesignals.com for further details.