RS14100 SoC & Modules

Redpine Signals RS14100 WiSeMCU™ family of SoCs and modules are the industry's first Wireless Secure MCU family with a comprehensive multi-protocol wireless sub-system. It has an integrated ultra-low-power microcontroller, a built-in wireless subsystem, advanced security, high performance mixed-signal peripherals and integrated power-management

Solution Highlights

  • Efficient on-chip application processor based on ARM® Cortex®-M4F with up to 180 MHz performance, up to 4 MB dedicated flash
  • Co-existence of multiple wireless protocols including 802.11a/b/g/n (2.4 GHz and 5 GHz), dual-mode Bluetooth 5 and 802.15.4 (capable of running Thread or ZigBee®)
  • Ultra-low power consumption with multiple power modes to reduce the system energy consumption
  • Multiple levels of security including PUF (Physically Unclonable Function), Crypto HW accelerators, Secure Bootloader and Secure Zone to create a highly secure system
  • Fully integrated and wireless certified modules with multiple sizes as small as 4.63 mm x 7.8 mm
  • Integrated networking and wireless stacks for ease of integration
  • Leading edge RF performance providing long range and higher throughputs
  • Unique peripherals like ULP sub-system, voice activity detection (VAD) and up to 8 capacitive touch sensor inputs

Block diagram

  • ARM Cortex-M4 core with up to 180 MHz
  • Integrated FPU, MPU and NVIC
  • SWD and JTAG debug options
  • Internal and external oscillators with PLLs
  • Flash In-Application Programming (IAP), In-System Programming
  • (ISP) and Over-the-Air Wireless Firmware Upgrade
  • Power-On Reset (POR), Brown-Out and Black-out Detect (BOD) with separate thresholds
  • Up to 4 MB integrated Quad-SPI flash with inline AES engine and XIP
  • Up to 400 KB SRAM
  • 4-way set-associative 16KB I-Cache
  • HW device identity and key storage with PUF
  • Trusted Execution Environment with Secure Boot loader
  • Accelerators: AES128/256, SHA256/384/512, RSA, ECC, ECDH, RNG, CRC
  • Compliant to single-spatial stream IEEE 802.11 a/b/g/n, 802.11j (hosted mode) with dual band (2.4 and 5GHz) support
  • Support for 20 MHz and 40 MHz channel bandwidths
  • Transmit power up to +20 dBm1 with integrated PA
  • Receive sensitivity as low as -97 dBm1
  • Application data throughput up to 40 Mbps1 in TCP mode
  • Compliant to dual-mode Bluetooth 5
  • Transmit power up to +20 dBm1 with integrated PA
  • Receive sensitivity as low as -104 dBm1
  • <5 mA1 transmit current in BT 5 mode, 0 dBm output power, 2 Mbps data rate
  • Data rates: 125/500 kbps, 1, 2, 3 Mbps
  • Compliant to IEEE 802.15.4, 2.4 GHz
  • Transmit power up to +20 dBm1 with integrated PA
  • Receive sensitivity of -102 dBm1
RF Features
  • Integrated baseband processor with calibration memory, RF transceiver, high-power amplifier, balun, T/R switch and flash memory
  • Dual external antenna (diversity supported)
  • Ultra-low power wake-up receiver with secure wakeup pattern to prevent battery drain attack
Embedded Wi-Fi Stack
  • Support for Embedded Wi-Fi Client mode, Wi-Fi Access point mode, Wi-Fi Direct and Enterprise Security
  • Supports advanced Wi-Fi security features: WPA/WPA2-Personal and Enterprise (EAP-TLS, EAP-FAST, EAP-TTLS, EAP-PEAP, EAP-LEAP, PEAP-MSCHAP-V2)
  • Integrated TCP/IP stack (IPV4/IPV6), HTTP/HTTPS, DHCP, ICMP, SSL 3.0/TLS1.2, Web sockets, IGMP, DNS, DNS-SD, SNMP, FTP Client
  • Wi-Fi firmware upgrade and provisioning
  • Support for concurrent Wi-Fi, dual-mode Bluetooth 5 and 802.15.42
Embedded Bluetooth Stack
  • EDR+2.1, 4.0, 4.1, 4.2 and 5.0
  • BT LE 1 Mbps, 2 Mbps and Long Range modes Ppiconet and scatternet
  • BT profile support1 for SPP, A2DP, AVRCP, HFP, PBAP, IAP, GAP, SDP, L2CAP, RFCOMM, GATT, IAP1, IAP2
Embedded Zigbee Stack
  • ZigBee PRO and Thread stack embedded
  • Supported modes: ZigBee Coordinator, Router1 , End device
  • Supported profiles: Zigbee Light Link (ZLL), Home Automation (HA) and Smart Energy (SEP)
MCU Sub-system Power Consumption
  • Active current of ~15uA/MHz1 in low power mode
  • Deep sleep mode current: ~400 nA1
  • Dynamic Voltage & Frequency Scaling
  • Deep sleep mode with only timer active - with and without RAM retention
Wireless Sub-system Power Consumption
  • Wi-Fi standby associated current of < 50 uA1
  • Wi-Fi tx current = 220 mA1, rx current of 40 mA1
  • BLE tx current = TBD, rx current = 6 mA1
Digital Peripherals
  • USB HS OTG with integrated HS transceiver
  • 10/100 Mbps Ethernet MAC with RMII
  • SDIO 3.0 host and slave, SD/eMMC
  • 3x USART, 4x SPI, 3x I2C, 2x I2S, SIO, CAN 2.0B
  • Timers: 5x 32-bit, 1x 16/32-bit, 1x 24-bit, WWDT, RTC, RIT, QEI
  • Up to 85 GPIOs with GPIO multiplexer
Analog Peripherals
  • 12-bit 16-ch, 5 Msps ADC, 10-bit DAC
  • 3x op-amps, 2x Comparators and Temperature Sensor
  • 8 capacitive touch sensor inputs
  • Voice Activity Detection (VAD)
Software and Regulatory Certifications
  • Wi-Fi Alliance2
  • ZigBee Certification2, Bluetooth Qualification2
  • Regulatory certifications (FCC, IC, CE, ETSI, TELEC)2
Operating Conditions
  • Single supply: 2.1 to 3.6V or 1.85V
  • Operating temperature: -40°C to +85°C (Industrial grade)
  • Modules with and without integrated antenna
  • SoC packages - WLCSP, QFN and BGA
Evaluation Kit:
  • P/N: RS14100-EVK1
Package Code Package Type Dimensions (mm) Frequency Band Integrated Antenna
CA0 LGA,110 9.1 x 9.8 x 1.0 Single Band (2.4 GHz) No
CC0 LGA,110 9.1 x 9.8 x 1.0 Dual Band (2.4 / 5 GHz) No
CA1 LGA, 84 TBD Single Band (2.4 GHz) Yes
CC1 LLGA, 84 TBD Dual Band (2.4 / 5 GHz) Yes
B00 LGA,113 4.63 x 7.80 x 1.0 Single Band (2.4 GHz) No
B01 LGA,113 4.63 x 7.80 x 1.0 Dual Band (2.4 / 5 GHz) Yes
Package Code Type of Package Dimensions, Pitch (mm) Frequency Band
WMS WLCSP, 79 3.51 x 3.60 x 0.5, 0.4 Single Band (2.4 GHz)
QMS QFN, 84 7 x 7 x 0.85, 0.5 Single Band (2.4 GHz)
BTS BGA, 196 6 x 6 x 0.9, 0.5 Single Band (2.4 GHz)

Part Number Wireless Other Wireless CPU Freq Flash+RAM Security Peripherals SoC Packages (ppg) Module Packages (ppg)
RS14100-0B00- 1100-ppg BT5 None 100 MHz 1 MB+208 KB     QMS,WMS,BTS B00, B01
RS14100-SB00-1105-ppg SB+BT5 None 100 MHz 1 MB+208 KB   USB+VAD QMS,WMS,BTS B00, B01,CA0, CA1
RS14100-SBT0-24SF-ppg SB+BT5+ZB/THR None 180 MHz 4 MB+208 KB Secure USB+Ethernet+ ULP+VAD+CAN QMS,WMS,BTS B00, B01,CA0, CA1
RRS14100-SBT1-24SF-ppg2 SB+BT5+ZB/THR Wake-Fi 180 MHz 4 MB+208 KB Secure USB+Ethernet+ ULP+VAD+CAN QMS,WMS,BTS B00, B01,CA0, CA1
RS14100-DB00-1100-ppg DB+BT5 None 100 MHz 1 MB+208 KB       CC0, CC1
RS14100-DB00-110F-ppg DB+BT5 None 100 MHz 1 MB+208 KB   USB+VAD+Ethernet   CC0, CC1
RS14100-DBT0-240F-ppg2 DB+BT5+ZB/THR None 180 MHz 4 MB+400 KB   USB+VAD+Ethernet   CC0, CC1
RS14100-DBT1-240F-ppg2 DB+BT5+ZB/THR Wake-Fi 180 MHz 4 MB+400 KB   USB+VAD+Ethernet   CC0, CC1

Note: Replace 'ppg' with desired SoC / Module Packages code;
SB: Single Band Wi-Fi (2.4 GHz); DB: Dual Band Wi-Fi (2.4/5 GHz); ZB: ZigBee; THR: Thread

1: Subject to change. Contact Redpine Signals for final numbers.
2:Contact Redpine for availability