BT/ZB/ 802.11 n/ac Dual-band Transceiver RS8112

Overview

The RS8112 is an ultra low power and high performance RF transceiver for Bluetooth, zigbee and WLAN IEEE 802.11 a/b/g/n/ac applications. It supports simultaneous BT/ZB and WLAN operation and has an integrated high-efficiency 2.4GHz & 5GHz CMOS PA with integrated Baluns for both bands in transmit mode. It has an analog interface to the SoC with integrated MAC/BBP, making this an ideal companion RF to Redpine’s 1x1 Wi-Fi Technology.

Features

  • Input unregulated supply (1.8V-3.6V) with in-built LDOs for all Analog /RF blocks. 3.0-3.6V supply for the High Power-Amplifier.
  • Integrated Dual-band CMOS High Power amplifier with +27dBm P1dB (2.4GHz) and +25.5dBm P1dB (5GHz) in WLAN mode.
  • Ultra-low Power operation with programmable high-performance vs ultra-low-power modes.
  • Supported Message Bandwidths 2.5 MHz to 40MHz in WLAN mode.
  • Supported Message Bandwidths 0.56 MHz to 20MHz in BT mode.
  • Operational temperature -40°C to 85°C
  • Available at low-cost QFN 48pin 6mm x 6mm package.
  • Integrated 2.4-2.5GHz power amplifier with 18dBm output power @ 3% EVM for 802.11 b/g/n.
  • Integrated 4.9-5.9GHz power amplifier with 16.5dBm output power @ 3% EVM for 802.11 a/n.
  • WLAN mode Rx Chain Noise Figure: 3dB (2.4G), 3.7dB (5G) (Typ, High Perf Mode).
  • BT mode Rx Chain Noise Figure: 6dB (Typ, High Perf Mode).
  • Serial Gain control interface for low pin-count.
  • Automatic Power-up VCO Calibration, Filter Cut-off Calibration and Rx DC Offset calibration.
  • Tx RF Loopback for Baseband assisted Tx IQ Imbalance, Tx DC Offset and PA Linearity calibration.
  • Lowest RBOM with integrated Tx Baluns, Accurate Temperature sensor and XTAL Oscillator with fast-start up and digital frequency calibration.
  • Meets tighter OOB emissions mask for usage in 802.11 and other high-output power applications.
  • Block Diagram
  • Specifications
  • Applications
  • Support
//