Half Mini Card Dimensions

30 x 26.8 x 5.35

Mini PCI Express (PCIe) Card
(Dual-band 802.11a/b/g/n Wi-Fi + Bluetooth 4.0 + ZigBee)

RS9113 USB Half Mini Card is based on Redpine Signals RS9113 ultra-low-power Convergence chip. It offers Dual-band 1x1 802.11n, Dual-mode Bluetooth 4.0 and ZigBee 802.15.4 in a single device over USB in a Mini PCIe Card form factor. Read more


Description

The RS9113 USB Half Mini Card is based on Redpine Signals RS9113 ultra-low-power Convergence SoC. It offers dual-band 1x1 802.11n, dual-mode Bluetooth 4.0 and ZigBee 802.15.4 in a single device over USB in a Mini PCIe Card form factor. It is an ideal multi-protocol wireless expansion board for IoT Gateways. The RS9113 USB Half Mini Card is a high performance, long range and ultra-low power device and includes a multi-threaded MAC processor called ThreadArch®, baseband digital signal processor, calibration OTP memory, dual-band RF transceiver, dual-band high-power amplifiers, baluns, diplexers, diversity switch, dual-band antenna, u.FL connector and Quad-SPI flash.

The software architecture for the USB Half Mini Card, n-Link®, realizes a host-based architecture where the necessary MAC and PHY layers are implemented in the device to support high-performance, long range WLAN, Bluetooth and ZigBee applications in a 32-bit host processor over USB interface.

Design Diagram

Features

  • Ideal multi-protocol wireless expansion board for IoT Gateways
  • WLAN Compliant with IEEE 802.11 a/b/g/n with dual band support.
  • WLAN transmit power up to +18dBm and receiver with sensitivity of -97dBm.
  • Wi-Fi Direct, Enterprise Security, Client and Access Point modes of operation.
  • Bluetooth Compliant with dual-mode Bluetooth v4.0
  • Bluetooth transmit power up to 15dBm (class-1) with integrated PA
  • Bluetooth receiver with -94dBm sensitivity.
  • ZigBee Compliant with IEEE 802.15.4
  • ZigBee output powers up to +15dBm with integratedPA and high performance ZigBee receiver with -102dBm sensitivity.
  • Embedded ZigBee Pro stack.
  • Supports advanced security features: WPA/WPA2-Personal and Enterprise(EAP-TLS, EAP-FAST, EAP-TTLS, EAP-PEAP)
  • Seamless integration with 32-bit processors over USB.
  • Fully integrated solution available now for Intel Moon Island and Baytrail platforms (Quark and Atom processor families)
  • Drivers available now for Wind River Linux 5.0.1, Linux Kernels 2.6.30 to 3.16 and Android 4.4.3

Specifications

  • IEEE 802.11 a/b/g/n, 802.11j, 802.11d/e/i, 802.11w, 802.1X, 802.11k,
    802.11v, 802.11r, 802.11h
    Bluetooth v2.1 EDR, v4.0
    802.15.4-2009 (2.4 GHz)
  • 802.11n: from 6.5 Mbps to 150 Mbps (MCS 0-7)
    802.11a/g: from 6 Mbps to 54 Mbps
    802.11b: from 1 Mbps to 11 Mbps
    Bluetooth: 1, 2, 3Mbps
    802.15.4-2009: 250Kbps
  • OFDM with BPSK, QPSK, 16-QAM, 64-QAM
    802.11b with CCK and DSSS
    Bluetooth: GFSK, DQPSK, 8DPSK
    802.15.4-2009: DSSS
  • WMM and WMM Power Save Support
  • 1-SS, 40MHz bandwidth, Greenfield Preamble, Short-GI, 1 spatial stream STBC, RIFS, A-MSDU, A-MPDU, Aggregation with Block-ack, A-MSDU inside A-MPDU and Virtual AP support
  • Scatternet, Adaptive Frequency Hopping, Interlaced scanning, 15 active slaves in proprietary mode, hold, sniff and park modes
  • CCM* security, orphan scanning, coordinator realignment
  • Wi-Fi client, Access point, Wi-Fi Direct
  • Master, slave, scatternet
  • ZigBee Coordinator, Router†, End device
  • USB 2.0
  • 3.0-3.6V
  • Industrial Grade -40°C to +85°C
  • Wi-Fi Alliance Compliance (802.11b/g/n, WPA, WPA2 Personal and Enterprise, WMM, WMM-PS, WPS, Wi-Fi Direct, Voice-Personal,
    Protected management frames†),
    Cisco CCX v5,
    Bluetooth-SIG Qualification,
    Worldwide Regulatory Compliance:
    FCC (IDs are XF6-RS9113SB, XF6-RS9113DB)
    IC (IDs are 8407A-RS9113SB, 8407A-RS9113DB)
    CE/ETSI,
    TELEC,
    SRRC
  • Wi-Fi: 18 dBm for 802.11b DSSS
    17 dBm for 802.11g/n OFDM
    12 dBm for 802.11a/n OFDM
    Bluetooth: 15 dBm
    ZigBee : 15 dBm
  • Wi-Fi: 1Mbps -97 dBm (< 8% PER)
    54 Mbps -76.5 dBm (< 10% PER)
    MCS7(20MHz) -73 dBm (< 10% PER)
    MCS7(40MHz) -69.5 dBm (< 10% PER)
    Bluetooth: 1 Mbps -94 dBm
    2 Mbps -92 dBm
    3 Mbps -84 dBm
    BTLE(1Mbps) -91 dBm
    ZigBee: 250 Kbps -102 dBm (< 8% PER)
  • †: These features are not supported by current software releases. Contact Repine Signals Sales (sales@redpinesignals.com) for details.
    ‡: These certifications are in progress at this time. Contact Redpine Signals Sales (sales@redpinesignals.com) for more details and for certifications not listed here.

Device Ordering Information

The device numbering is based on the following naming convention. All the devices are labeled as RS9113-NBZ-D3N

Product Brief

Title Type Size Date
PDF 1090 KB Jan 2019


Datasheet

Title Type Version Size Date
PDF v1.4 2.8 MB Aug 2018


EVK Resources

Title Type Version Size Date
PDF v1.1 150 KB Jan 2017
PDF v8.0 128 KB Jan 2016
PDF 2.27 MB Jun 2017
PDF v2.7 6.16 MB Dec 2017
PDF v1.2 668 KB Jun 2017


Hardware Resources

Title Type Version Size Date
3D Models Dimensions
Zip v1.1 2.74 MB Jul 2017
Zip v1.1 4.51 MB Jul 2017
Allegro Footprints
Zip v1.1 23.3 KB Jun 2017
Symbols
Zip (.OLB) v1.1 4 KB Jun 2017
Zip (.OLB) v1.1 559 KB Jun 2017
Certifications and Declarations
Zip 39.8 MB Aug 2017
Zip 16.1 MB Jan 2015
Zip 10.8 MB Feb 2015
Zip 625 KB May 2016
ZIP 926 KB Mar 2016
Zip 242 KB Nov 2018
Zip 30 KB May 2018


Software Resources

Title Type Version Size Date
PDF v2.10 1.71 MB Dec 2017
PDF v1.6.3 2.10 MB Nov 2019
PDF v1.0 793 KB Jun 2017
PDF v1.0 591 KB Feb 2016
PDF v1.2 438 KB Dec 2017
PDF 576 KB Jul 2017
PDF 294 KB Dec 2016

Tools & Softwares

For RS9113 n-Link Linux/Windows/Android software package, please click here


RS9113 EVKs

Part Number Product Image Wireless Variant User Guides Frequency Band Buy Now
RS9113-NBZ-S1X-EVB Wi-Fi + BT 5 + ZB RS9113 EVB Product Brief Single Band Buy
RS9113-NBZ-D1X-EVB Wi-Fi + BT 5 + ZB RS9113 EVB Product Brief Dual Band Buy