RS9113 FIPS EVB
(Dual-band 802.11 a/b/g/n Wi-Fi)

RS9113 FIPS 140-2 Level 1 certified Wi-Fi EVB is based on Redpine Signals' RS9113 ultra-low-power Convergence chip. These modules offer Dual-band 802.11a/b/g/n Wi-Fi (2.4 GHz and 5 GHz). Read more

Description

The RS9113 based FIPS 140-2 Level 1 validated Wi-Fi modules based on Redpine Signals' RS9113 ultra-low-power Convergence SoC. These modules offer dual-band 1x1 802.11n wireless connectivity. They are high performance, long range and ultra-low power modules and include a multi-threaded MAC processor called ThreadArch®, digital and analog peripheral interfaces, baseband digital signal processor, calibration OTP memory, dual-band RF transceiver, dual-band high-power amplifiers, baluns, diplexers, diversity switch and Quad-SPI flash.

The module's embedded firmware includes the WLAN protocol stack along with support for WPA/WPA2-PSK and WPA/WPA2-Enterprise (EAP-TLS, EAP-TTLS, EAP-PEAP) ecurity algorithms. It is a fully-integrated solution for secure embedded low-end wireless applications. The modules can be connected to 8/16/32-bit host processors through SPI, UART, USB and USB-CDC interfaces.

Features

  • *FIPS 140-2 Level 1 Certification for modules with and without antenna
  • FIPS Approved and non-FIPS Approved modes of operation
  • 802.11 a/b/g/n operation over 2.4 GHz and 5 GHz bands
  • Two module variants : with and without integrated antenna
  • Ultra low power operation with power save modes
  • Module supports single supply 3.0 to 3.6 V operation

Evaluation Board

The Evaluation Board is designed to configure the module to use the inter-face on which power supply is detected. This is indicated through the LEDs mounted on the board.

Evaluation Kit

Evaluation Kit Contents

The RS9113 FIPS 140-2 Module Evaluation Kit comes with the following components:

  • RS9113 FIPS 140-2 Module Evaluation Board
  • USB Pen Drive
  • Micro A/B-type USB cable
  • SDIO Adaptor Cable
  • SPI Adaptor Cable
  • Female - Female Cables

Specifications

  • IEEE 802.11 a/b/g/n, 802.11d/e/i
  • 802.11n: from 6.5 Mbps to 72.2 Mbps (MCS 0-7)
    802.11a/g: from 6 Mbps to 54 Mbps
    802.11b: from 1 Mbps to 11 Mbps
  • OFDM with BPSK, QPSK, 16-QAM, 64-QAM
    802.11b with CCK and DSSS
  • 1-SS, Greenfield Preamble, Short-GI, 1 spatial stream, STBC, RIFS,
    A-MSDU, A-MPDU, Aggregation with Block-ack, A-MSDUinside
    A-MPDU and Virtual AP support
  • IPv4 and IPv6, DHCP Server/Client, HTTP Server/Client,Static and Dynamic Webpages with JSON Objects (for HTML Server), ICMP, Websockets, DNS Client, IGMP, SNMP
  • AES with 128-bit key and 256-bit key in CBC mode Encrypt/Decrypt,
    ● key wrapping (Cert. #3299) ● AES CCM (Cert. #3300)
    ● AES-128 CMAC (Cert. #3316) ● SHA-1, 256 (Cert. #2628)
    HMAC-SHA1 and HMAC-SHA256 (Cert. #2003)
    RSA PKCS#5 v1.5 with 2048-bit key and SHA-256 for Digital Signature
    Generation/Verification (Cert. #1689)
    SP800-90 DRBG HASH_DRBG (Cert. #754)
    SP800-108 KDF (Cert. #50)
    CVL: SP800-135 TLS v1.0 KDF (Cert. #474)
  • Hardware non-deterministic random number generator (for seeding Approved DRBG)
    Diffie-Hellman (key agreement; key establishment methodology provides 112 bits of encryption strength)
    RSA (key wrapping; key establishment methodology provides 112 bits of encryption strength)
  • RC4 ● DES ● MD4 ● MD5
  • Cryptographic Algorithm Tests:
    ● SHA1 KAT ● SHA256 KAT ● HMAC-SHA1 KAT ● HMAC-SHA256 KAT ● RSA 2048 Signature Generation KAT ● RSA 2048 Signature Verification KAT ● AES-128 CBC Encrypt KAT ● AES-128 CBC Decrypt KAT ● AES-256 CBC Encrypt KAT ● AES-256 CBC Decrypt KAT ● SP800-38F AES Key Wrap Encrypt KAT ● SP800-38F AES Key Wrap Decrypt KAT ● SP800-90 DRBG KAT ● SP800-135 TLS KDF KAT ● SP800-108 KDF KAT ● ES-CCM KAT
    Software/Firmware Tests
    ● Firmware integrity test (32-bit checksum) ● Boot-loader integrity test (32-bit checksum)
    Critical Functions Tests:
    SHA1 checksum of configuration parameters
  • Firmware load test: AES CMAC Test
    Manual key entry test: 256-bit PSK
    Continuous random number generator tests
    ● Continuous test on SP800-90 DRBG
    ● Continuous test on non-Approved NDRNG
  • FCC (ID is XF6-RS9113DB)
    IC (ID 8407A-RS9113DB)
    CE/ETSI, TELEC**, SRRC**
  • Wi-Fi: 18 dBm for 802.11b DSSS
    17 dBm for 802.11g/n OFDM
    12 dBm for 802.11a/n OFDM
  • Wi-Fi: 1Mbps -97 dBm (< 8% PER) 54 Mbps -76.5 dBm (< 10% PER) MCS7 -73 dBm (< 10% PER)
  • *: Module with antenna part certification is in progress, please contact Redpine Signals Sales for status .
  • **: These certifications are in progress at this time. Contact Redpine Signals Sales(sales@redpinesignals.com) for more details and for certifications not listed here.

Product Brief

Title Type Size Date
PDF 1.24 MB Jul 2019


Datasheet

Title Type Version Size Date
Datasheet PDF v1.0 1.11 MB Feb 2016


EVK Resources

Title Type Version Size Date
PDF v1.1 150 KB Jan 2017
PDF v8.0 128 KB Jan 2016
PDF 2.27 MB Jun 2017
PDF v2.7 6.16 MB Dec 2017
PDF v1.1 1.87 MB Sep 2015


Software Resources

Title Type Version Size Date
PDF v1.7 1.0 MB Nov 2015
PDF v1.0 99 KB Jul 2015
PDF v1.0 466 KB Jul 2015
PDF v1.0 370 KB Jul 2015

Tools & Softwares

Title Type Version Size Date
RS9113.NBZ.WC.FIPS.OSI.1.2.6 Zip v1.2.6 14.17 MB Aug 2017

RS9113 FIPS EVKs

Part Number Product Image Wireless Variant User Guides Frequency Band Buy Now
RS9113-N00-DXF-EVB Wi-Fi Only RS9113 FIPS EVB Product Brief Dual Band Buy
Part Number Buy Now
RS9113-N00-DXF-EVB Buy